Chevrolet Captiva Manuals

Chevrolet Captiva Service & Repair Manual: Wheel Alignment Adjust

Front

Caster

Front caster is not adjustable. If front caster angle is not within specifications, inspect for suspension support misalignment or front suspension damage. Replace any damaged suspension components, as required.

Camber

Front suspension strut does not have to be removed from vehicle to perform following steps.
Move top of wheel in or out to proper specifications.
1. Position vehicle properly on an alignment rack.
2. Loosen both of front suspension strut nuts (1) enough to allow for movement, Fig. 1.
3. If front suspension strut needs to be modified, perform following steps, noting following:
  a. Remove tire and wheel assembly.
  b. Loosen, but do not remove upper front suspension strut bolt from knuckle.
  c. Remove lower front suspension strut bolt.
  d. Push front suspension strut inward and install front suspension strut bolt in bottom hole of knuckle. This will hold knuckle in place to allow lower hole to be enlarged.
  e. Enlarge outer flange hole (1) to match that of inner flange hole, using a file, Fig. 2.
  f. Remove lower front suspension strut bolt from knuckle.
  g. Install lower front suspension strut bolt and tighten both bolts.
4. Adjust front camber to specification, Fig. 3.
5. Install strut to knuckle nuts (1) and torque to 136 ft. lbs., Fig. 1.
6. Verify front camber adjustment specification and adjust again, as required.

Rear

Camber

1. Loosen upper control arm nut (2), Fig. 4.
2. Rotate upper control arm adjusting bolt (1), to adjust camber, Fig. 4.
3. Snug upper control arm nut (2), do not tighten at this time, Fig. 4.
4. Reinspect rear camber specifications and adjust, as required.
5. Hold upper control arm adjusting bolt (1), Fig. 4.
6. Torque upper control arm nut (2) to 121 ft. lbs., Fig. 4.
7. Repeat procedure for other rear wheel.

Fig. 1

Fig. 2

Fig. 3

Fig. 4

    Toe Adjust
    Front Steering linkage inner tie rod must rotate freely from boot seal surface. Do not allow boot to rotate. 1. Position and lock steering wheel with ...

    More about:

    Chevrolet Captiva Service & Repair Manual > Tires: Component Replacement
    Tire Pressure Indicator Sensor Replacement Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Do not use paints, lubricants, or corrosion inhibitors on fasteners, or fastener joint surfaces, unless specifi ...

    Chevrolet Captiva Owners Manual

    Chevrolet Captiva Service & Repair Manual

    © 2024 Copyright www.ccaptiva.com - 0.0065