Chevrolet Captiva Service & Repair Manual: Disc Brake Pad Wear Sensor R&R
| If electrical connection for disc
brake wear sensor originates from brake pad, sensor is a chip integral to
brake pad and is replaced as an assembly. |
| 1. |
Lift and support vehicle using a suitable
vehicle lift. |
| 2. |
Remove wheel and tire assembly as outlined
in "Wheel, Replace." |
| 3. |
Disconnect electrical connector. |
| 4. |
Remove brake caliper, if required. |
| 5. |
Remove disc brake wear sensor. |
| 6. |
Reverse procedure to install. Verify
sensors are functioning properly using a suitably programmed scan
tool. |
|
Front
Removal
Caution: Support the brake
caliper with heavy mechanic wire, or equivalent, whenever it is separated
from its mount and the hydraulic flexible brake hose is still connec ...
1.
Remove the front floor console accessory
trim plate upper, Fig. 1.
2.
Remove parking brake actuator switch
bolts, Fig. 1.
...
More about:
Chevrolet Captiva Owners Manual > Vehicle Checks: Battery
Refer to the replacement number
shown on the original battery label
when a new battery is needed. See
Engine Compartment Overview on
page 10-4 for battery location.
Warning
Battery posts, terminals, and
related accessories contain lead
and lead compounds, chemicals
known to the State of Cal ...
Disc Brake Caliper R&R
Parking Brake Activation Switch R&R