Chevrolet Captiva Manuals

Chevrolet Captiva Service & Repair Manual: Parking Brake Motor R&I

Actuator

1. Raise and support the vehicle.
2. Remove the tire and wheel.
3. Remove the park brake shoes.
4. Disconnect the park brake cable eye from the actuator lever, Fig. 1.
5. Remove parking brake actuator, Fig. 1.
6. Reverse procedure to install. Adjust parking brake.

Control Module

Removal

1. Disable the parking brake cable adjuster.
2. Turn the ignition to the OFF position.
3. Raise and support the vehicle.
4. Disconnect the parking brake intermediate cable nut (1) from the electronic parking brake control module spindle by rotating the nut counterclockwise, Fig. 2.
5. Disconnect the parking brake intermediate cable and position the cable aside.
6. Remove the electronic parking brake control module front cover (1), Fig. 3.
7. Disconnect the electronic parking brake control module electrical connector.
8. Remove the electronic parking brake control module bracket bolts (1), Fig. 4.
9. Remove the electronic parking brake control module and bracket assembly (1), Fig. 5.
10. If necessary, remove the electronic parking brake control module bolts (1), Fig. 6.
11. Remove the electronic parking brake control module bracket (1), Fig. 7.
12. Inspect the electronic parking brake control module bracket sleeves and insulators. Replace any damaged or missing sleeves or insulators.
13. Remove the electronic parking brake control module (1) from the rear cover, Fig. 8.

Installation

Ensure the park brake intermediate cable fitting is engaged in the actuator in the spindle.
When installing the parking brake intermediate cable nut to the electronic park brake module spindle, hold the spindle housing securely to avoid distorting the housing.
1. Install the electronic parking brake control module to the rear cover.
2. Install the electronic parking brake control module bracket to the electronic parking brake control module, if removed.
3. Install the electronic parking brake control module bolts and torque the bolts to 80 inch lbs.
4. Install the electronic parking brake control module and bracket assembly.
5. Install the electronic parking brake control module bracket bolts and torque the bolts to 89 inch lbs.
6. Connect the electronic parking brake control module electrical connector.
7. Install the electronic parking brake control module front cover.
8. Inspect the O-ring seals on the electronic parking brake control module spindle and the parking brake intermediate cable for damage and correct positioning and replace, if necessary.
9. Install the parking brake intermediate cable fitting to the spindle.
10. Connect the parking brake intermediate cable nut to the electronic parking brake control module spindle by rotating the nut clockwise and torque to 53 inch lbs.
11. Program the electronic parking brake control module.
12. Enable the parking brake cable adjuster.

Fig. 1

Fig. 2

Fig. 3

Fig. 4

Fig. 5

Fig. 6

Fig. 7

Fig. 8

    Parking Brake Cable R&R
    Front Removal 1. Disable the parking brake cable adjuster. 2. Turn the ignition to the OFF position. 3. Raise an ...

    Parking Brake Shoes R&I
    Warning: Avoid taking the following actions when you service wheel brake parts: Do not grind brake linings, do not sand brake linings and do not clean wheel brake parts with a dry b ...

    More about:

    Chevrolet Captiva Owners Manual > Airbag System: Airbag System Check, Replacing Airbag System Parts after a Crash
    Airbag System Check The airbag system does not need regularly scheduled maintenance or replacement. Make sure the airbag readiness light is working. See Airbag Readiness Light on page 5-12. Caution If an airbag covering is damaged, opened, or broken, the airbag may not work properly. Do no ...

    Chevrolet Captiva Owners Manual

    Chevrolet Captiva Service & Repair Manual

    © 2022 Copyright www.ccaptiva.com - 0.0053